Mirae Mx200 - Page 149

Chapter 6 Programming 6-3
<Figure 6-2ᆞ
Open a CAD ASCII file
>..........................................................6-7
<Figure 6-3ᆞ
CAD Conversion Program
>.......................................................6-8
<Figure 6-4ᆞ
Error message window
>............................................................6-9
<Figure 6-5ᆞ
Setting Fiducial Mark Type
>...................................................6-9
<Figure 6-6ᆞ
Setting CAD Coordinate and Unit
>......................................6-10
<Figure 6-7ᆞ
Rotation Origin setting
>............................................................6-11
<Figure 6-8ᆞ
PWB Information setup
>..........................................................6-11
<Figure 6-9ᆞ
CAD Conversion result windpw
>............................................6-11
<Figure 6-
10ᆞ
Select a programming method
>.............................................6-12
<Figure 6-
11ᆞ
Conversion result window
>.....................................................6-12
<Figure 6-
12ᆞ
.Run the ProgramEditor program
>.........................................6-14
<Figure 6-
13ᆞ
ProgramEditor main window
>................................................6-14
<Figure 6-14ᆞ Select a programming method >.................................6-15
<Figure 6-15ᆞ Select a starting status of job program >................6-15
<Figure 6-16ᆞ Open a Placement Data file >...............................................6-
16
<Figure 6-17ᆞ The window displayed when Blank is selcted >........6-17
<Figure 6-18ᆞ PWB information setup window
>...........................................6-17
<Figure 6-19ᆞ Fiducial Information main window
>........................................6-22
<Figure 6-20ᆞ Select Fiducial Mark
>............................................................6-23
<Figure 6-21ᆞ Select Geometric or Real >...................................................6-
23
<Figure 6-22ᆞ Window Box adjustment
>.......................................................6-24
<Figure 6-23ᆞ Select mark DB >.................................................................6-
24
<Figure 6-24ᆞ Select Part Number
>.............................................................6-25
<Figure 6-25ᆞ Select a package in the Part Information window..... 6-26
<Figure 6-26ᆞ The window displayed when the Package Icon is selected >
6-26