Mirae Mx200 - Table of Contents

6-2 Mx100/200 Series Operation Manual
USING COMP DB
EDITOR................................................................................6-27
SETTING OTHER PART
INFORMATION.......................................................6-40
PLACE
DATA............................................................................................................6-
48
ENTERING LACE
DATE....................................................................................6-48
DATA
CHECK.......................................................................................................6-
51
OPTIMIZE.........................................................................................................
.........6-53
LINE
OPTIMIZER.................................................................................................6
-53
MIRAE OPTIMIZER PHOENIX
1.0.0.8.............................................................6-56
PROGRAMEDITOR AFTER
OPTIMIZATION................................................6-64
DIRECT
TEACHING................................................................................................6-68
INTELLIGENT FEEDER
DATA.........................................................................6-68
NOZZLE ASSINGMENT ANC INFORMATION
CHECK..............................6-70
PART INSPECTION AND PIC
FUNCTION.....................................................6-72
PRODUCTION.................................................................................................
........6-78
PRODUCTION & DRY RUN & BYPASS
RUN...............................................6-78
PRODUCTION
ENVIRONMENT......................................................................6-82
UTILITY
MENU.....................................................................................................6-84
Figure List
<Figure 6-1ᆞ
OfflineEditor execution
window>....................................................7