Chapter 5 Preparation for Programming 5-21
• Send Packet to VME(Versa Module Euro)
Shows the commands sent to VME (Main Control System).
• Received interrupt code from VME
Shows the interrupt codes received from VME. Interrupt code is not a response to the request
sent from Application not data created under a certain condition.
• Received packet from VME
Shows the data or messages received from VME. These messages are typically responses to the
commands shown in ‘DDE Command from Application’ and ‘Send Packet to VME’, starting with
V4081, P2021, M1051, etc.
• Current VME IP
Shows IP Address of the connected VME. To enter an exact address, see the initial window
displayed on the MrTerminal when the system starts booting.
• Setup
The Setup button is activated only if communication is disconnected. This button is used to set
basic data to connect communication.
To Next Page
Loading...
