Mirae Mx200 - Page 262

xx
NOZZLE
CHECK...............................................................................................................................................
......4-9
CHECKING THE BLOWING LEVEL VALUE AT THE NOZZLE
TIP............................................................4-12
CHECKING THE VACUUM PRESSURE AT THE NOZZLE
TIP..................................................................4-13
NOZZLES APPLICABLE BY
COMPONENT....................................................................................................4-14
FAN (FILTER) CHECK
........................................................................................................................................4-20
MONTHLY CHECK (EVERY 500
HOURS)...................................................................................................4-21
LINEAR SCALE
CHECK......................................................................................................................................4-21
LINEAR SLIDE
CHECK........................................................................................................................................4-23
Z-AXIS NOZZLE SHAFT MOVING
CHECK......................................................................................................4-26
Z-AXIS RACK & PINION
CHECK........................................................................................................................4-27
R-AXIS BEARING
CHECK...................................................................................................................................4-29
TIMING BELT AND PULLEY
CHECK................................................................................................................4-31
Z-AXIS LINEAR SLIDE
CHECK..........................................................................................................................4-32
AIR FILTER
CHECK..............................................................................................................................................
4-33
CASTING OFF NG PART
CHECK.....................................................................................................................4-35
QUARTERLY CHECK (EVERY 1500
HOURS)............................................................................................4-36
LEAD SCREW /LINEAR SLIDE
CHECK...........................................................................................................4-36
ANC
CHECK...............................................................................................................................................
............4-37 CONVEYOR
CHECK............................................................................................................................................4-
40
TIMING BELT
CHECK..........................................................................................................................................4-
41