Chapter 3 Installation 3-9
Equipment
Shipping
(Transportation)
Use a forklift when lifting and moving the packed system.
To move the system with a forklift, insert the fork into the front packing
plate (The front packing plate is marked with a Mirae logo.)
Make sure to keep the system horizontally when moving the packed
system with a forklift.
Make sure to keep the system horizontally when transporting the
packed system by vehicle, ship, airplane or any other transporting
method, etc. Check tilt of the system by the tilt check label (Tip & Tell) on the
front packing plate.
Equipment
Unpacking
Unpack the system as follows:
Pay attention not to apply impact 1. Remove the upper packing plate with
a screwdriver. on the system in all unpacking
process.
2. Remove the setscrews at the both ends of the three upper fixation supports with a
screwdriver.
Pay attention not
to drop the upper
fixation support
when removing
it.
3. Remove the
setscrews
from the
front and upper packing plates with a screwdriver (The front and
rear wooden plates are marked with a Mirae logo.)
4. Remove the setscrews from the packing plates on both sides.
5. Remove the setscrews from the floor fixation support using a
screwdriver
6. Lift the equipment with a forklift and attach the 4 feet.
To Next Page
Loading...
