No part of this book may be reproduced or transmitted in any form or by any means, electronic or mechanical, including
photocopying, recording, or by any information storage or retrieval systems, without written permission from Mirae Corp.
Information in this document is subject to change without notice.
Mirae SMT, Mirae SMT Mounter, Off-line Program Editor, and On-line Control & Monitoring are registered trademarks of
Mirae Corp.
Windows, and Windows 2000/XP ystem are registered trademarks of Microsoft Corporation.
Mirae CORP.
SMT Business Department, Mirae CORP.
http://www.mirae.co.kr http://www.mirae.com
714 Baeksuk-dong, Chun An City
Choong-nam, 330-220, Korea
TEL : 82 + 41-621-5070
FAX : 82 + 41-621-5090
ii
SAFETY INSTRUCTIONS
Incorrect or insecure handling can cause personal injury or malfunction of the
equipment, therefore, be sure to keep the following instructions.
1. For safe operation, read this manual thoroughly. Refer to the maintenance manual for safety
signs. For safety mark, refer to maintenance manual(Maintenance)part.
2. Check the location of Emergency Switch before you start operating the machine. In case of
emergency, be sure to stop equipment immediately.
3. Do not operate the machine with wet hands.
4. Before you open any door or cover, make sure to power off the machine.
5. Do not operate the machine after setting the door safety sensor. Manipulation of safety sensor
performed by anyone other than the authorized personnel may cause malfunction.
6. Before starting the machine, check all safety instructions, especially, in case of operation of
multiple operators. check the other operator’s security first and start operation.
7. Be cautious to keep electrical parts (e.g., VME Rack, Power Box, Amp, PC, and Boards) away
from water or oil.
8. Be sure to power off the machine before disassembling all connector.
9. Be sure to power off the machine before dissembling any connector.
10. Do not operate the machine in the state of excessive high temperature, dust, noise, or air
pressure.
To Next Page
Loading...
