Installation
Parameter Parameter value
Subnet mask Defines the range of an IP address, which are
available for this network.
Gateway IP address of the gateway. Gateway has to be in
the same range as the network of eth0.
First-start response
The IP addressing after a first start depends on whether a static IP addressing is already stored from
a previous configuration. A static IP addressing (IP address, subnet mask, gateway) entered manually
is stored and remains available after a first start. This means that the communication server remains
accessible via Ethernet interface in the same way as before the first start.
If no IP addressing is entered (e.g. after initial delivery), the communication server is started with DHCP
after a first start. The communication server tries to log on with the DHCP server and to enter its host name
on the DNS server. If log on is successful the communication server is accessible via the host name.
If the communication server cannot find a DHCP server within 90 seconds, it deactivates the DHCP mode
and is then accessible via the standard IP address (see Table 2) with a direct connection.
Note:
DHCP is deactivated only temporarily and is reactivated after a subsequent restart
Cable types
The Ethernet switch on the communications server features Auto MDI/MDIX. With the automatic detection
straight or crossover LAN cables can be used for all connection types.
Configuration
The Ethernet interfaces routed to the front panel can be configured individually in the IP addressing (
=9g) view. In addition to Auto modes, manual settings are also possible for Speed and MDI type.
The Ethernet interfaces routed to the front panel can be configured individually in the network view of the
SMB Controller Manager.
Status LED
The status of the Ethernet interface LAN1 is indicated on the LED display panel.
Release 7.1
System Manual for Mitel SMB Controller 154
To Next Page
Loading...
Need help?
General
