Mitsubishi Electric CR800 Series - Force Control Mode Settings; Force Control Characteristics Settings

183
17.4.27.2. Force control mode
Set the parameters, [Coordinate system], [Control mode of axes], [Stiffness coefficients], and [Dumping
coefficients] which are used by the control mode of force control function.
After you change the parameter values, you can rewrite the parameters in the robot controller by tapping the
[Write] button.
17.4.27.3. Force control characteristics
Set the parameters, [Gain], [Instruction], and [Detection] which are used by the control feature of force control
function.
The “Mode switch judgment/Speed reference” button is displayed in this software 3.1 or later. The controller
which can set the parameters [Mode switch judgment] and [Speed reference] is as follows.
Table 17-6 Robot controller which can set the parameters [Mode switch judgment] and [Speed reference]
Controller
S/W Ver. of the controller
CR750-D/CRnD-700
Ver.S3g or later
CR750-Q/CRnQ-700
Ver.R3g or later
CR800-D/R/Q
Can be used with all versions
(1) In the case of using version 3.0 or earlier