Mitsubishi Electric CR800 Series - Copy Program Files

82
13.3. Copy
The program files are copied.
Copying of the entire program file or only the command statements or only the position variables is possible.
Tap the [Copy / Move] button on "Program list window", and “Copy / Move” window will appear.
1) Select the program files to copy from the “Source” list, and designate the destination (robot or folder in the USB
memory) at the “Destination” to copy to.
The multiple program files can be selected at the same time, but for copying with changing its name, only ONE
program must be selected.
2) Tap the [Copy] button (<a>), and “Setting for copy” window will appear.
3) Set the condition of the copy, and tap the [OK] button. (<b>)
(Note 1) Copy of [PRG Ext. Position] is supported by version 2.2 or later of this software.
<b>
(Ver.2.1 or earlier)
(Ver.2.2 or later)
(Note1)
<a>