Mitsubishi Electric CR800 Series - Operation of the Electric Hand

26
9.15.1. Operation of the Electric Hand
The Electric Hand operation function can be used this software Version 2.5 or later. And the software version of the
controller which you can use is as follows.
Controller
Software version of the controller
CR750-D/CRnD-700
Version S2a or later
CR750-Q/CRnQ-700
Version R2a or later
CR800-D/R/Q
Can be used with all versions
The electric hand table method can be used this software Version 3.1 or later. And the software version of the
controller which you can use is as follows.
Controller
Software version of the controller
CR750-D/CRnD-700
Version S3e or later
CR750-Q/CRnQ-700
Version R3e or later
CR800-D/R/Q
Can be used with all versions
(1) In the case of using version 3.0 or earlier
<a>
<c>
<d>
<b>
<g>
<e>
<f>