Mitsubishi Electric CR800 Series - Movement State

100
[Delete variable] The value of the variable being watched now is changed. Variable identifier to which
the value is changed is tapped double or [Change] button is tapped while selected.
Variable value change window is displayed.
About the hexadecimal number display
The variable displayed with "Watch monitor" and "Change value of variable" can be switched to the
hexadecimal number / the decimal number.
Please select the type, which wants to be displayed with "View" on each screen.
Please refer to the following for the variable, which can be displayed by the hexadecimal number.
Integer
The displayed variable can be switched to the hexadecimal
number/the decimal number.
Float
When it is 0 below the decimal point, it is possible to switch to
the hexadecimal number/the decimal number. However, the
value is the one within the range of -9999999-9999999.
String
The hexadecimal number is not displayed.
Location
The hexadecimal number is not displayed.
As for the value displayed by the hexadecimal number, &H is added to the head of the value.
15.3.1.3. Movement State
With the operation confirmation, the robot's movement range, current position and hand open / close state, etc.,
can be confirmed.
<c>