Mitsubishi Electric CR800 Series - Reset Controller Errors and Program State; Cycle Stop Control

225
Fixed-dimension
Description
Off Press the button to move the axis.
High
The axis will move the amount specified by the JOG parameter
movement amount H.
Low
The axis will move the amount specified by the JOG parameter
movement amount L.
Runtime button image
Creation button image
Description
Move J1 axis.
Move J2 axis.
Move J3 axis.
Move J4axis.
Move J5 axis.
Move J6 axis.
Move J7 (additional axis) axis.
Move J8 (additional axis) axis.
Move in X coordinate direction.
Move in Y coordinate direction.
Move in Z coordinate direction.
Rotate around the X axis.
Rotate around the Y axis.
Rotate around the Z axis.
Move L1 (additional axis) axis.
Move L2 (additional axis) axis.
Press the T / B [TEACH] switch to activate T / B, then turn the servo power on and press the T / B enable switch to
continue using the jog button.