Mitsubishi Electric CR800 Series - Page 59

45
4) The screen <a> which confirms the putting part in the destination of the movement or the copy is
displayed. Select ahead or after of the line <b> for pasting, and tap [OK] key <c>. And the command line is
added to the selected part <d>
5) When MELFA-BASIC IV is used, the screen <a> which confirms the line number and the line interval at
the copy destination is displayed. Please change the line number if necessary in the keyboard screen
displayed by tapping [edit] key <b>. Please set the first line number for the newly moved or copied to
“Line# to paste to:”. The line interval (at the movement or the copy of two or more lines) is set. <c> The
cursor of both input boxes moves with [Tab], [<<], and the [>>] key. <d> When input ends, tap the [OK]
key<e> of the keyboard.
<b>
<e>
<b>
<a>
<c>
<d>
<a>
<c>
<d>