＜Workpieces＞
●If the workpiece falls during movement or while it is secured, it may cause serious injury.
・Do not place the workpiece in an unstable location. Do not place the workpiece in a position outside
of the measuring range of the product.
・Do not place tools or other unnecessary objects on the measuring table.
・When a heavy workpiece is moved or placed, ensure that there are no people other than the
operator nearby.
・When a heavy workpiece is moved or placed, ensure that there are no people other than the
operator nearby.
・When placing a small or light workpiece, always hold it firmly with both hands.
・When handling workpieces, use protective equipment that is appropriate for the size, weight, and
shape of the workpiece.
●If the workpiece falls while the product is in operation, death or serious injury may occur.
・Do not measure the workpiece unless it is completely secured.
・Do not place tools or other unnecessary objects on the measuring table while measuring.
・Use protective equipment when handling a workpiece.
●Moving a workpiece that is placed on an auxiliary surface plate may lead to serious injury. In
particular, if there is a substance such as oil on the upper surface of the measuring table, the
adhesion may require a strong force to move the auxiliary surface plate. If a strong force
overcomes the adhesion between the auxiliary surface plate and the measuring table, only the
auxiliary surface plate that has been pushed with a strong force may suddenly glide away,
causing the workpiece to fall on your feet.
・When moving the auxiliary surface table and the workpiece on the measuring table, always move
the auxiliary surface table and the workpiece separately.
●There is a risk of injury when handling workpieces with sharp edges or corners.
●Placing a workpiece on the turntable that exceeds the maximum loading mass may damage the
turntable or the product.
・Observe the maximum loading mass for the workpiece.
・Place the workpiece within the measurement range.
・When placing a workpiece, be careful that you do not apply any strong shocks to the workpiece.
To Next Page
Loading...
