Mitutoyo CONTRACER CV-2100 - Page 74

No. 99MBB793A
5-4
Z-axis scale overspeed
• 11: Lit (red)
• 6: Lit (green)
• 2: Lit (green)
• 1: Lit (red)
Z-axis scale overspeed
occurred.
If the error is not solved
even after the power is
turned on again, it is likely
that a break occurred in
the wiring inside the
cabinet or another place
or the scale is dirty.
Contact your dealer or the
nearest Mitutoyo sales
office/service center.
X-axis scale overspeed
• 11: Lit (red)
• 7: Lit (green)
• 4: Lit (green)
• 2: Lit (green)
• 1: Lit (red)
X-axis scale overspeed
occurred.
If the error is not solved
even after the power is
turned on again, it is likely
that a break occurred in
the wiring inside the
cabinet or another place
or the scale is dirty.
Contact your dealer or the
nearest Mitutoyo sales
office/service center.
X-axis drive unit
Tracking error
• 11: Lit (red)
• 7: Lit (green)
• 2: Lit (green)
• 1: Lit (red)
State of inability to move
correctly, because of
reasons such as faulty
rotation of the motor of the
X-axis drive unit
Check if the stylus is
interfered by any
obstacles. If problem is
not resolved, contact your
dealer or the nearest
Mitutoyo sales
office/service center.
X-axis drive unit
current limit error
• 11: Lit (red)
• 7: Lit (green)
• 3: Lit (green)
• 1: Lit (red)
State of inability to move
correctly, because of high
load to the motor of the
X-axis drive unit
Check if the stylus is
interfered by any
obstacles. If problem is
not resolved, contact your
dealer or the nearest
Mitutoyo sales
office/service center.
11
10
9
8
7
6
5
4
3
2
1
11
10
9
8
7
6
5
4
3
2
1
11
10
9
8
7
6
5
4
3
2
1
11
10
9
8
7
6
5
4
3
2
1
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit