Mitutoyo ID-C Series - Contact Point Replacement

69
No. 99MAH056A
5 Setting Parameters
(Short press) / (Long press)
1 Press the [F2] key.
» Year display blinks.
» To skip the number of years setting, press the [F2] key again (shifts to 8 (number of
months setting)).
Setting the number of years
2 Press and hold the [F2] key.
» Tens place of the year blinks.
3 Press the [F1] key or [F3] key.
» Each time the key is pressed, the value will change by one.
4 Press the [F2] key.
» Thetensplaceisconrmedandtheunitsplaceblinks.
5 Press the [F1] key or [F3] key.
» Each time the key is pressed, the value will change by one.
6 Press the [F2] key.
» Theunitsplaceisconrmedandtheyeardisplayblinks.
7 Press the [F2] key.
» Month display blinks.
» To skip the number of months setting, press the [F2] key again (shifts to 11 (number
of days setting)).
Setting the number of months
8 Press and hold the [F2] key.
» Tens place of the month blinks.
9 Set the number of months in the same manner as above in 3 to 6.
10 Press the [F2] key.
» Day display blinks.
» To skip the number of days setting, press the [F2] key again (shifts to step
4 ).
Setting the number of days
11 Press and hold the [F2] key.
» Tens place of the day blinks.
12 Set the number of days in the same manner as above in 3 to 6.
13 Press the [F2] key.
» Calibration date becomes settable and [CALib] blinks.