Moog G392-004 - Ethernet IP-Address Menu (IP)

MSDServoDrive AC-AC Operation Manual
moog
50
Id. no.:CA65642-001 Date:03/2012
to the glossaryto the table of contents
4.4.4 Ethernet IP-address menu (IP)
An Ethernet TCP/IP interface serves the purpose of service and diagnostics interface.
The IP-address is factory set to 192.168.39.5. It can be changed with the PC software
Moog
DriveADministr Ator 5 or via the display.
Menu level Pa-
ram-
eter
Value
range
Meaning Explanation
1 2
IP
Iu b0 00..FF IP address
udate Byte0
Setting of byte 0 of the IP-address in
hexadecimal representation
(e.g. “05” at 192.168.39.5)
b1 00..FF IP address
udate Byte1
Setting of byte 1 of the IP-address in
hexadecimal representation
(e.g. “27” at 192.168.39.5)
b2 00..FF IP address
udate Byte2
Setting of byte 2 of the IP-address in
hexadecimal representation
(e.g. “A8” at 192.168.39.5)
b3 00..FF IP address
udate Byte3
Setting of byte 3 of the IP-address in
hexadecimal representation
(e.g. “C0” at 192.168.39.5)
Ir - - IP reset to
factory setting
To reset the IP-address to factory setting
(192.168.39.5)
Su b0 00..FF Subnetmask
udate Byte0
Setting of byte 0 of the subnet mask in
hexadecimal representation
(e.g. “00“ at 255.255.255.0)
b1 00..FF Subnetmask
udate Byte1
Setting of byte 1 of the subnet mask in
hexadecimal representation
(e.g. “FF“ at 255.255.255.0)
b2 00..FF Subnetmask
udate Byte2
Setting of byte 2 of the subnet mask in
hexadecimal representation
(e.g. “FF“ at 255.255.255.0)
b3 00..FF Subnetmask
udate Byte3
Setting of byte 3 of the subnet mask in
hexadecimal representation
(e.g. “FF“ at 255.255.255.0)
Sr - - Subnetmask
reset to
factory setting
To reset the subnet mask to factory
setting (255.255.255.0)
Table 4.8 IP-address menu
Exemplary configuration of the subnet mask
In this example the subnet mask is changed from 255.255.255.0 auf 122.255.255.0.
T1
T2
Tx
Tx
Back
Back
Back
Apply
>5 s>5 s
<5 s
T2
<5 s
T1 T2
T1 T2
T1 T2
Back
T1 T2
Back
T1 T2
T1 T2
T1 T2
T1 T2
T1
T2
T1
T1
Back
T1 T2
T2
Press button Tx
(x=1, 2) repeatedly
until desired menu
appears on display
Press button Tx
(x=1, 2) once
Press any button
Press button T1 and T2
simultaneously
Value NOT
saved
Value
saved
Fig. 4.2 Exemplary configuration of the subnet mask