Phone Books and Clock
3-62 G24-L AT Commands Reference Manual April 15, 2008
requested, all entries that contain data within that range are returned. If a listing fails in a G24-L
error, +CME ERROR: <err> is returned.
This command can also be used to obtain information about the number of entries and the
maximum size of a phone number and alpha tag fields in the phone book.
This command acts on the currently active phone book, as selected with the +CPBS command
(Refer to “+CPBS, Select Phone Book Memory”, page 3-60).
The following table shows the +CPBR parameters.
Command
Type
Syntax Response/Action Remarks
Set
+CPBR=<index1>
[,<index2>]
[+CPBR:
<index1>,<number>,<type>,<text>
[<CR><LF>
+CPBR:
<index2>,<number>,<type>,<text>]]
OK
or:
+CME ERROR: <err>
The Set command returns
phone book entries.
Test
+CPBR=? +CPBR: (list of supported
<index>s),[<nlength>], [<tlength>]
OK
The Test command
returns the entry range
supported by the current
storage as a compound
value and the maximum
lengths of the <number>
and <text> fields.
Table 3-34: +CPBR Parameters
<Parameter> Description
<index1>
<index2>
Index for a given phone book entry
<number> Phone number of a given entry
<type> The address type of a phone number
129 Use for local call
145 Use “+” for international access code
128 Unknown
"128" is used to represent an email address or a mailing list. In this case, <ph_type>
can be used to further differentiate between the two.
<text> Text identifier for a phone book entry, according to the character set as specified by
command +CSCS.
<nlength> The maximum number of digits in the <number>.
<tlength> The maximum number of characters in the <text> entry
To Next Page
Loading...
