Motorola AT Commands G24-L User Manual

Hardware Information
3-132 G24-L AT Commands Reference Manual April 15, 2008
+CBAUD, Baud Rate Regulation
This command sets the baud rate. The baud rate of the G24-L is changed/set to the request value
<rate> written in the command.
Specifying a value of 9 or 0 disables the function and allows operation only at rates automatically
detectable by the G24-L. The specified rate takes effect following the issuing of any result
code(s) associated with the current command line.
The UART is configured according to the request, or to the specific constant baud rate or auto
baud rate after output "OK" response to the terminal. For example, AT+CBAUD=8 is equivalent
to AT+CBAUD=57600. Using AT+CBAUD with the <rate> value other than 9 or 0 disables the
auto baud rate detection feature.
The following table shows the +CBAUD parameters.
Example
AT+CBAUD=57600
or
AT+CBAUD=8 //These commands have the same effect
OK
Command Type Syntax Response/Action
Set
AT+CBAUD=<n>
AT+CBAUD=<rate>
OK
or:
ERROR
Read
AT+CBAUD? +CBAUD: <rate>
Test
AT+CBAUD=? +CBAUD: (list of supported <n>s, list of
supported <rate>s)
Table 3-84: +CBAUD Parameters
<Parameter> Description
<n> <rate> 0 Auto baud rate
1 600
2 1200
3 2400
4 4800
5 9600
6 19200
7 38400
8 57600
9 Auto baud rate
10 115200
11 300
12 230400
13 460800
The default value is 9.

Motorola AT Commands G24-L Specifications

General

Brand	Motorola
Model	AT Commands G24-L
Category	Network Hardware
Language	English