Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-267
The following table shows the Set Event List parameters.
Note: Each language code consists of a pair of alphanumeric characters, defined in ISO 639 [4].
Each character is coded on one byte using the SMS default 7-bit coded alphabet, as
defined in TS 23.038, with bit 8 set to 0. For a list of language codes, refer to the section
that follows.
Table 3-189:
Set Event List Parameters
<Parameter> Description
<Result> 5 User Activity event
6 Idle Screen Available event
8 Language Selection event
9 Browser Termination event
<Data> None User Activity event
None Idle Screen Available event
0 Browser Termination event (User terminated)
1 Browser Termination event (Error terminated)
4 Language Selection event, with string coded as follows:
Byte(s) Description Length
1 Language tag 1
2 Length=’02’ 1
3-4 Language 2
To Next Page
Loading...
Need help?
General
