Motorola AT Commands G24-L User Manual

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-65
field already exists in the PB, the new record will update the old one. If the writing fails in a
G24-L error, +CME ERROR: <err> is returned.
Note: The "FD" phone book supports single wild card characters (?) and prefixes of a number
in the telephone number field. In cases of fixed dialing, these entries in the "FD" phone
book define a group of permitted numbers.
Call indications related to a fixed dialing entry containing wild cards or only a prefix of
a number do not display any <alpha> identifier.
The following table shows the +CPBW parameters.
Command
Type
Syntax Response/Action Remarks
Set
AT+CPBW=[<index>][,
<number>
[,<type>[,<text>]]]
OK
or:
+CME ERROR: <err>
Test
AT+CPBW=? +CPBW: (list of
supported
<index>s),[<nlength>],
(list of supported
<type>s),[<tlength>]
OK
This command queries the
allowable command field and
sizes.
Table 3-36: +CPBW Parameters
<Parameter> Description
<index> Index for a given phone book entry
<number> Phone number of a given entry
<type> The address type of a phone number
129 Use for local call
145 Use “+” for international access code
128 Unknown
Note: "128" is used to represent an email address or a mailing list. In this case,
<ph_type> can be used to further differentiate between the two.
<text> Text identifier for a phone book entry, according to the character set as specified by
command +CSCS.
<nlength> The maximum size of a phone number, in digits. There is a limited number of PB
records that can be stored with this length. The number of "long" PB records depends
on the size of the SIM card EXT1 extension file. If the extension file is full, an
attempt to store a new record with more than 20 digits returns an error.
<tlength> The maximum number of characters in the <text> entry. This applies to GSM standard
characters only. Non-GSM standard character sets and extended GSM characters
require additional space in storage. In some cases, when using such characters the text
cannot be stored. In this case, the G24-L returns a "text string too long"error.

Motorola AT Commands G24-L Specifications

General

Brand	Motorola
Model	AT Commands G24-L
Category	Network Hardware
Language	English