Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-289
Event
+MIPXOFF: <Socket ID>
Example
+MIPXOFF: //The G24-L detects that the accumulating buffer 1 has reached its
Xoff watermark.
From this point, the terminal is not allowed to send data, until it receives the +MIPXON
command.
MIPXON, Flow Control - Xon
This command is the unsolicited event that the G24-L sends to the terminal when it detects that it
has free memory in the accumulating buffer and can process new +MIPSEND requests, after the
+MIPXOFF event.
Event
+MIPXON: <Socket ID>
Example
+MIPXON: 1 //The G24-L pushed the data into the protocol stack on socket 1
and is able to handle more data from the terminal.
MIPCONF - Configure Internal TCP/IP stack
This command allows to configure TCP stack parameters, such as retransmissions number, upper
and bottom limits of retransmission timeout, close delay. It can be used to configure TCP socket
To Next Page
Loading...
Need help?
General
