Hardware Information
3-140 G24-L AT Commands Reference Manual April 15, 2008
+MGGIND, GSM/GPRS Service Indicator
This command configures the service indicator line of pin 49 of the 70 pin connector to be GPRS
or GSM registration indicator.
The IO line (pin 49) function according to the current registration state (in service or not) of the
specific service indicator configuration.
Note: IO line (pin 49) outcome depends on +MCWAKE configuration.
The following table shows the +MGGIND parameters.
Example
AT+MGGIND=0
OK
AT+MGGIND?
OK
+MGGIND: 0
AT+MGGIND=1
OK
AT+MGGIND?
+MGGIND: 1
OK
AT+MGGIND=?
+MGGIND: (0-1)
OK
Command Type Syntax Response/Action
Set
AT+MGGIND=<state> OK
or:
+CME ERROR: <err>
Read
AT+ MGGIND ? +MGGIND: <state>
OK
or:
+CME ERROR: <err>
Test
AT+ MGGIND =? +MGGIND: (list of supported
<state>s)
OK
Table 3-91: +MGGIND Parameters
<Parameter> Description
<state> 0 GPRS registration indicator.
1 GSM registration indicator.
To Next Page
Loading...
Need help?
General
