Motorola AT Commands G24-L - Appendix A: Reference Tables; AT Commands Alphabetical Summary; AT Commands (Alphabetical; A-1 at Commands (Alphabetical)

April 15, 2008 G24-L AT Commands Reference Manual A-1
Appendix A: Reference Tables
This appendix contains the following sections:
• AT Commands Alphabetical Summary, below
• Character Set Table CS1: (GSM -> UCS-2), Page -17
• Character Set Table CS2: (ASCII <-> UTF-8), Page -21
• Character Set Table CS3: (UCS-2 <-> UTF-8), Page -21
• Character Set Table CS6: (UCS-2 Full Table), Page -21
• Character Set Table CS7: (ASCII table), Page -22
Note: Character Set Table CS6: (UCS-2) is provided on CD due to its size.
AT Commands Alphabetical Summary
The following table contains an alphabetical list of all the G24-L AT commands.
Table A-1: AT Commands (Alphabetical)
AT Command Description Page
$
This command displays a list of
all the AT commands supported
by the G24-L.
Page 3-7
%C
This command is supported for
backward compatibility only, and
has no effect.
Page 3-304
&C
This command determines how
the state of the DCD line relates
to the detection of the received
line signal from the distant end.
Page 3-136
&D
This command determines how
the G24-L responds when the
DTR (Data Terminal Ready)
status is changed from ON to
OFF during the online data state.
Page 3-138
&F
This command restores the
factory default configuration
profile.
Page 3-198