Motorola AT Commands G24-L - Page 412

AT Commands Alphabetical Summary
A-10 G24-L AT Commands Reference Manual April 15, 2008
+EMPC
This command unlocks or
resets the first PLMN of the
inserted SIM.
Page 3-187
+EPIN
This command is only relevant
for phones that use SIM cards. It
verifies the PIN2 indicator.
Page 3-181
+FMI
This command requests
manufacturer identification.
Page 3-1
+FMM
This command requests the
model identification.
Page 3-2
+FMR
This command requests the
revision identification.
Page 3-3
+GMI
This command requests
manufacturer identification.
Page 3-1
+GMM
This command requests the
model identification.
Page 3-2
+GMR
This command requests the
revision identification.
Page 3-3
+GSN
This command requests the
product serial number
identification.
Page 3-3
+ICF
This command determines the
local serial port start/stop
(asynchronous) character framing
used by the DCE when accepting
DTE commands and transmitting
information text and result codes,
whenever these are not done
automatically.
Page 3-142
+IPR
This command is responsible for
setting and saving the request
baud rate.
Page 3-133
+MADIGITAL
This command switches between
analog and digital audio modes.
Page 3-170
+MAFEAT
This command controls the
various algorithm features, such
as sidetone, echo cancel and
noise suppress.
Page 3-169
+MAMUT
This command controls the
muting/unmuting of all input
paths (MIC, HDST_MIC,
DIGITAL_RX).
Page 3-168
+MAPATH
This command sets/requests the
active input accessory, and the
output accessory for each feature.
Page 3-163
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page