Getting Started 1 - 7
7. Install the battery.
8. After completing initial MC9596 setup or after replacing a SIM card:
a. Press the red Power button.
b. On the Today screen, tap Wireless Manager.
c. Ensure Phone is on.
d. Press the red Power button to suspend the MC9596.
e. Perform a warm boot. See Resetting the MC9500-K on page 3-3.
f. Make a call to verify cellular connection.
Installing the Battery
To install the battery:
1. Insert the battery, top first, into the battery compartment.
2. Press the battery down into the battery compartment until the battery release latches snap into place.
Figure 1-11
Inserting the Battery
3. The MC9500-K powers up automatically after inserting the battery, if the battery has been charged previously.
Charging the Battery
Before using the MC9500-K for the first time, charge the battery using either a charging cable or a cradle:
•
USB Charging Cable
•
Charge Only Cable
•
Single Bay USB Cradle
NOTE For detailed information about WWAN activation and settings, refer to the MC9500-K Series Mobile Computer
Integrator Guide.
Battery
Battery Release Latch
Battery Release Latch
CAUTION Ensure that you follow the guidelines for battery safety described in Battery Safety Guidelines on page 9-2.
NOTE For cable and cradle setup and charging procedures refer to the MC9500-K Series Mobile
Computer Integrator Guide.
To Next Page
Loading...
