TN-5516/5518 User’s Manual Featured Functions
3-59
Management VLAN ID
Setting Description Factory Default
VLAN ID from 1
to 4094
This assigns the VLAN ID of this TN-5500. 1
Enable GVRP
Setting Description Factory Default
Enable or Disable Enable or disable GVRP (GARP VLAN Registration
Protocol).
Enable
Port Type
Setting Description Factory Default
Access This port type is used to connect single devices without
tags.
Trunk Select Trunk port type to connect another 802.1Q
VLAN aware switch or another LAN that combines
tagged and/or untagged devices and/or other
switches/hubs.
Access
ATTENTION
For communication redundancy in the VLAN environment, set Redundant Port, Coupling
Port, and Coupling Control Port as Trunk Port since these ports act as the backbone to
transmit all packets of different VLANs to different TN-5500 units.
Port PVID
Setting Description Factory Default
VID range from 1
to 4094
This sets the default VLAN ID for untagged devices that
connect to the port.
1
Fixed VLAN List (Tagged)
Setting Description Factory Default
VID range from 1
to 4094
This field will be active only when selecting the Trunk
port type. Set the other VLAN ID for tagged devices that
connect to the Trunk port. Use commas to separate
different VIDs.
None
Forbidden VLAN List
Setting Description Factory Default
VID range from 1
to 4094
This field will be active only when selecting the Trunk
port type. Set the VLAN IDs that will not be supported
by this trunk port. Use commas to separate different
VIDs.
None
To Next Page
Loading...
Need help?
General
