TN-5516/5518 User’s Manual Featured Functions
3-25
User Data Encryption Key (for SNMP V1, V2c, V3 and V3 only)
Setting Description Factory Default
Enable
This enables data encryption using the
specified data encryption key (between 8 and
30 characters).
No
Disable No data encryption No
Trap Settings
1
st
Trap Server IP/Name
Setting Description Factory Default
IP or name
This specifies the IP address or name of the
primary trap server used by your network.
None
1
st
Trap Community
Setting Description Factory Default
Max. 30 characters
This specifies the community string to use for
authentication.
Public
2nd Trap Server IP/Name
Setting Description Factory Default
IP or name
This specifies the IP address or name of the
secondary trap server used by your network.
None
2nd Trap Community
Setting Description Factory Default
Max. 30 characters
This specifies the community string to use for
authentication.
Public
Trap Mode
Setting Description Factory Default
Trap
Select this option to use SNMP Trap message to
indicate event occurrence.
Trap
Inform
Select this option to use SNMP Inform message
to indicate event occurrence. SNMPv2 provides
an inform mechanism. When an inform message
is sent from the SNMP agent to the NMS
(network management system), the receiver
sends a response to the sender acknowledging
receipt of the event. This behavior is similar to
that of the get and set requests.
Trap
To Next Page
Loading...
Need help?
General
