HYDROCAL 1005 Manual for Installation and Operation Page 13/111
Then, if everything is working correctly put the housing in correct position and secure it with the
knurled thumbscrews.
The measuring cycle of the HYDROCAL1005 unit is synchronized on the hour mark; this means
the first measuring value is available approx. 2, 22 or 42 min. after the hour mark and can be read
on the display.
After first start-up, in all cases date and time have to be checked on the HYDROCAL1005 display
and eventually have to be adjusted manually in clock settings (chapter 3.7.5.2) or with HydroSoft
(chapter 4.10.7).
To Next Page
Loading...
