HYDROCAL 1005 Manual for Installation and Operation Page 12/111
2.6 Completion of Installation
At first, date and time must be setup, refer to chapter
4.9.5.3.
The HYDROCAL1005 has a sub menu allowing con-
figuration of time, date as well as clock
The Hydrocal is currently not installed.
After the mount button is activated,
the Detect-Cycle will start.
The Hydrocal filled up to level 1.
A circulation is made to remove air from the system.
Finally system is drained to level 0.
The Hydrocal is installed in normal operation.
(Currently Sync. Wait)
The selected Button is the unmount button.
(Controlled draining and stopping)
To Next Page
Loading...
