MTS Systems FlexTest SE Service Information

Model 493.02 Controller Service
Automated Configuration
Introduction
Introduction
24
Series 793 software
options
The following products are available as options with the Model 793.00
System Software bundle:
• Model 793.10 MultiPurpose TestWare
®
(MPT)—A sophisticated
test design application. This application allows you to build test
procedures by defining and linking modular test activities together
and assigning triggering relationships between each activity.
• Model 793.11 Profile Editor
™
—A sophisticated arbitrary
waveform design application. This application allows you to
create arbitrary waveforms that can be played-out with the
MultiPurpose TestWare application.
Rack mounting
requirements
The Controller can be mounted in an equipment rack. When doing so
allow a minimum of 2 in. (5.1 cm) on either side of the Controller for
air flow. There are no spacing requirements for the top or bottom of
the Controller. If the equipment rack is equipped with doors, allow
adequate clearance for the front and rear of the Controller. The rear of
the Controller requires a minimum clearance of 6 in. (15.24 cm) to
accommodate cables.

MTS Systems FlexTest SE Specifications

General

Brand	MTS Systems
Model	FlexTest SE
Category	Controller
Language	English