MTS Systems FlexTest SE Service Information

Model 493.02 Controller Service
About Your Manuals
Preface
Preface
10
About Your Manuals
This manual provides detailed information about the installation,
cabling, and set-up of the MTS FlexTest SE Controller, including all
controller, computer (optional), sensor, I/O, and hydraulic
connections. This manual also provides basic information about
calibrating sensor/conditioner pairs, initial system tuning, and adjusting
servovalves.
Summary This manual includes the following chapters.
Chapter 1, “Introduction”—This chapter introduces a MTS FlexTest SE
Controller, and includes a table of the basic specifications of the
controller and the associated electronic components.
Chapter 2, “Installation”—This chapter covers the installation of the
MTS FlexTest SE Controller, including connections and mounting.
Chapter 3, “Cabling”—This chapter contains detailed cabling
information, including pin-out assignments of all the connectors.
Chapter 4, “Servovalve Controls”—This chapter describes servovalve
adjustments to optimize the interface between the controller and the
servovalve.
Chapter 5, “Sensors”—This chapter describes sensor signals,
connections, and cabling. Shunt calibration for DC sensors is also
described.
Chapter 6, “Calibration”—This chapter describes how to calibrate the
sensors connected to your system.
Chapter 7, “Tuning”—This chapter describes system tuning basics.
Appendix A, “Hydraulic Configurations”—This appendix describes
how to connect the Model 493.02 Chassis to a variety of MTS hydraulic
configurations.
Appendix B, “Model 493.07 HPU Converter”—This appendix describes
the Model 493.07 HPU Converter including connectors and jumper
configurations.
Appendix C, “Service Tools”—This appendix describes the FlexTest SE
Service Tools application.

MTS Systems FlexTest SE Specifications

General

Brand	MTS Systems
Model	FlexTest SE
Category	Controller
Language	English