Model 493.02 Controller Service
Cable Part Numbers
Cabling
46
Sensor cables See “Sensor Cable Part Numbers” on page 87 for a detailed list of
sensor cables.
For the most current part numbers, see the System Cable/Jumper Plug
493 Package Selection drawing (PN 700-000-656).
Box In 563160-xx 493.42 J51 N/A
Box Out 563160-xx 493.42 J52 100-057-246
Digital Input (Dig In) Per System 493.42 J54 N/A
Digital Output (Dig Out) Per System 493.42 J55 N/A
Analog In (Anlg In) Per System 493.42 N/A
Analog Out (Anlg Out) Per System 493.42 N/A
* -XX specifies cable length. –01 through –09 represent 10–50 ft. in 5 ft. increments. Higher
numbers represent custom cable lengths
.
† Jumper plugs are required if a cable is not installed.
‡ The connector is the 10/100 BaseT connector on the power PC module.
FlexTest SE Cables (part 2 of 2)
C
ABLE DESCRIPTION PART
N
UMBER
*
MODULE
C
ONNECTOR
JUMPER
P
LUG
†
To Next Page
