MTS Systems FlexTest SE Service Information

Model 493.40 I/O Carrier Connections
Model 493.02 Controller Service
Cabling
55
Accelerometer Connections
An accelerometer requires the Model 493.48 Acceleration daughter
board installed in a Model 493.40 I/O Carrier module.
• Each Model 493.48 Acceleration daughter board supports up to
three accelerometers.
I/O Carrier jumper
settings
Before installing a Model 493.48 Acceleration Conditioner daughter
board in a Model 493.40 I/O Carrier module, specific jumpers must be
set. Jumper settings depend on the number and configuration of your
system accelerometers.
In the example shown below, the Acceleration Conditioner supports
three accelerometers. The indicated three jumpers must be set on the
I/O Carrier module.

MTS Systems FlexTest SE Specifications

General

Brand	MTS Systems
Model	FlexTest SE
Category	Controller
Language	English