Muratec MFX-C3035 - For Netware 5.X;6 Novell Distributed Print Service (NDPS)

Printing With NetWare3-8
– [Ethernet Frame Type]:
Select [Auto]. (Select the frame type according to the network
environment.)
– [NetWare Print Mode]: Select [PServer].
– [Print Server Name]: Specify the print server name created in step
4.
– [Print Server Password]: Specify only when setting from the
NetWare server.
– [Print Queue Scan Rate]: Specify 1. (Change as necessary.)
– [Bindery/NDS]: Select [NDS].
– [Preferred NDS Context Name]:
Specify the name of the context that connects to Pserver.
– [Preferred NDS Tree Name]:
Specify the name of the tree that Pserver logs on to.
6 Restart the printer (turn the printer off, then on again).
7 Use the NetWare server console to load MONITOR.NLM.
8 Select the connection information and, in the active connection column,
check that the created Pserver is connected.
For NetWare 5.x/6 Novell Distributed Print Service
(NDPS)
" Before specifying settings for NDPS, check that the NDPS broker and
NDPS manager have been created and loaded.
" Also, before performing the following procedure, check that the TCP/
IP protocol has been set in the NetWare server, and check that the IP
address has been set for this machine and that this machine is on.
1 Log on to NetWare as an administrator from a client computer.
2 Start up NWadmin.
3 Right-click the organization or organizational unit container where you will
create the printer agent, and then click [NDPS Printer] on the [Create]
submenu.
4 In the [NDPS Printer Name] box, enter the printer name.
5 In the [Printer Agent Source] column, select [Create a New Printer Agent],
and then click the [Create] button.
6 Check the printer agent name, and then in the [NDPS Manager Name]
box, browse through the NDPS manager names, and register one.