Displaying the [Ethernet] screen 5-3
Displaying the [Ethernet] screen
From the [Ethernet] screen (Admin Settings), specify various network settings
for the machine.
From the Admin Settings screen, various settings are available to be changed
by the machine administrator. In order to display the Admin Settings screen,
the user must log on using the administrator password.
1 Press the [Utility/Counter] key.
2 Press [Admin Settings].
3 Type in the administrator password (Default: 12345678), and then press
[OK].
" If the administrator password is incorrectly entered three times,
machine operations are locked. If this occurs, turn the machine off,
then on again.
4 Press [Ethernet].
" Restart the machine if any of the following Ethernet settings are
changed.
îš„ [TCP/IP] - [Enable]
îš„ [TCP/IP] - [DHCP]
îš„ [TCP/IP] - [BOOTP]
îš„ [TCP/IP] - [ARP/PING]
îš„ [TCP/IP] - [SLP]
îš„ [TCP/IP] - [SNMP]
îš„ [TCP/IP] - [IPv6] - [Enable]
îš„ [TCP/IP] - [IPv6] - [Auto Setting]
îš„ [Netware]
îš„ [IEEE802.1X]
To Next Page
Loading...
Need help?
General
