Network Printing7-24
Adding a printer from the Network window
In Windows Vista/Server 2008, you can add a Web service device using the
addition function of the printer after connecting this machine.
" In Windows 7/Server 2008 R2, a window for specifying an installation
disk does not appear after the machine is connected to the computer.
To connect this machine as described in “Making the printer driver
known from the Network window” on page 7-23.
To use Web service print in Windows Vista/Server 2008/7, install the printer
driver before making it known to the computer with plug and play.
1 Install the printer driver for this machine.
" Install the printer driver using the installer or Add Printer Wizard. The
printer driver can be installed in any port. For details, refer to “Adding
an IPP Port using the Printer Driver CD/DVD” on page 7-11.
2 Turn on the power of the machine while it is connected to the network.
Since the printer is searched for, be sure to connect the machine to the
network.
3 To use Web Service print, check that [Network discovery] is enabled in
[Network and Sharing Center] on the computer.
4 Open the [Network] window.
– In Windows Vista/Server 2008, click [Start], and [Network].
– In Windows 7, open [Computer] and click [Network].
If [Network] is not displayed in [Computer], click the [Network and
Internet] category on the [Control Panel], and also click [View network
computers and devices].
To Next Page
Loading...
Need help?
General
