Network Connection 7-5
4 If you don’t set the gateway, go to step 5.
Specify the gateway address for this machine.
îš„ Specify the gateway address by pressing the buttons indicated below.
[Utility Settings] – [Admin Settings] – [Ethernet] – [TCP/IP] – [Gateway]
îš„ Change the setting, and then press [OK].
5 After specifying administrator settings, reset the printer so that it can print.
6 After "Welcome!" appears in the control panel of the machine, print the
configuration page, and then check the IP address, subnet mask and
gateway address that has been specified.
îš„ Print the configuration page by pressing the buttons indicated below. [Util-
ity Settings] – [User Settings] – [Print Settings] – [Print Reports] – [Config-
uration Page]
7 Install the printer driver and utilities.
To Next Page
Loading...
Need help?
General
