NANOTEC ELECTRONIC N5 - Copyright, Marking and Contact; Intended Use

Technical Manual N5 (CANopen)
1 Introduction
Manual
version
Date Changes Firmware
version
• Addition to the switching thresholds for digital inputs
1.5.0 08.04.2016
• Error corrections
• New chapter Interpolated Position Mode
FIR-v1614
1.5.1 22.07.2016 Additions and error corrections FIR-v1626
2.0.0 01/2018
• New chapter Environmental conditions
• New chapter Control modes
• New chapter Limitation of the range of motion
• New chapter Cycle times
• New chapter CANopen services
• Revision of chapter Commissioning
• Additions and error corrections
FIR-v1650
2.0.1 08/2018 Additions and error corrections FIR-v1650
1.2 Copyright, marking and contact
Copyright
©
2013 – 2018 Nanotec
®
Electronic GmbH & Co. KG. All rights reserved.
Nanotec
®
Electronic GmbH & Co. KG
Kapellenstraße 6
D-85622 Feldkirchen/Munich
Phone: +49 (0)89-900 686-0
Fax: +49 (0)89-900 686-50
Internet: us.nanotec.com
Microsoft
®
Windows
®
98/NT/ME/2000/XP/7/10 are registered trademarks of the Microsoft Corporation.
1.3 Intended use
The N5 controller is used to control stepper and BLDC motors and is designed for use under the
approved Environmental conditions.
Any other use is considered unintended use.
Note
Changes or modification to the controller are not permitted.
Version: 2.0.1 / FIR-v1650 9