7 Direction Finding Mode
140 IDA-3106 Narda
NOTE: Localization is determined from the results of triangulation and the distance
(level difference) when the Distance function is activated. You can quickly
see whether the additional level difference data provides a more accurate
determination of the position by switching the Distance function on and off.
Localization takes place in three steps:
1. Start localization.
2. Take bearings on the signal source from different locations and save the
measurements.
3. Display the bearings in the Map menu and calculate the transmitter
location.
Step 1: Start localization
Press the Localization softkey.
The softkey shows On and glows red. All the measurement results
saved until you press the softkey again are saved in the same data
set and used for subsequent localization.
To Next Page
Loading...
