5.4 Saving and loading setups
Narda IDA-3106 85
Selecting frequencies from a Transmitter Table
If you have selected and activated a Transmitter Table, you can use it in any
operating mode except Multi-Channel Power to quickly and easily switch
the center frequency Fcent and the CBW or Fspan. You can find more
information about setting the center frequency under Setting the center
frequency (Fcent) on page 91.
5.4 Saving and loading setups
Main Menu • Setups
You can use this menu to save all the settings as a setup or recall and load
setups that you have saved previously.
NOTE: Setups can only be created on the device itself. They cannot be created on
a PC. When you save a setup, the actual measurement settings for all
operating modes are always saved as well.
5.4.1 Saving settings as a setup
Main Menu • Setups
1. Make the desired settings on the device.
2. Switch to the Main Menu • Setups menu and press the Save Setup
softkey.
The entry box opens.
NOTE: You can also save a setup directly from an operating mode. This function is
found in the Display menu of the operating mode.
3. Enter a suitable name and press OK to confirm your entry.
The settings are saved as a new setup and displayed in the overview
bar.
5.4.2 Loading settings from a setup
Main Menu • Setups
Use the rotary control knob to highlight the desired setup and press the
Recall Setup softkey or the OK key.
The settings saved in the selected setup will be loaded and the
display switches to the measurement screen.
To Next Page
Loading...
