9 Level Meter Mode
178 IDA-3106 Narda
9.3 Operating mode specific functions
This section describes how to select a detector.
You can find information about the general settings and functions that are
present in several operating modes (such as Fcent, RBW / CBW, Reference
Level) in chapter 6 Common Functions on page 89.
9.3.1 Selecting the detector
In contrast with other operating modes, the Detector menu in Level Meter
mode allows selection of the detector types Peak and RMS. The following
can be displayed:
• Peak only
• RMS only
• Peak and RMS
To select a detector:
1. Press the Detector softkey.
2. Use the rotary control knob to select the desired averaging time and then
press the OK key to make the setting.
To select the averaging time:
1. Press the Detector softkey.
2. Press the RMS Average Time softkey.
3. Use the rotary control knob to select the desired averaging time and then
press the OK key to make the setting.
To Next Page
Loading...
