6.12 Using Multi-Channel Tables
Narda IDA-3106 117
6.11.2 Automatically hiding the status bars
You can hide the upper and lower status bars to allow more space for the
split screen display. You can link the hide function to activation of the
Magnifier function so that you do not have to hide the status bars manually
every time you switch to the split screen display.
To hide the status bars automatically:
The Marker • Display menu is active.
The Magnifier function is activated (Magnifier: On)
1. Press the Screen Arrangement softkey.
The Set Screen Arrangement fold-out window opens.
2. Use the rotary control knob and softkeys to highlight the item Hide at
Magnifier under Upper status bar or under Lower status Bar and
press the OK key.
The selected display is adjusted accordingly.
6.12 Using Multi-Channel Tables
All operating modes • Extras
1. Press the Select Multi-Ch. Table softkey.
A list of the available multi-channel tables is displayed.
2. Use the rotary control knob to select an item and press OK to confirm the
selection.
NOTE: Information about creating a multi-channel table is found under Displaying
and creating Multi-Channel Tables on page 79.
Selecting a channel
NOTE: You can find information about selecting channels in Multi-Channel Power
mode under Showing and hiding channels on page 213.
1. If necessary, change the multi-channel table using the Select Multi-Ch.
Table softkey.
2. Press the Select Channel softkey.
A list of the available channels is displayed.
3. Use the rotary control knob to select an item and press OK to confirm the
selection.
To Next Page
Loading...
