NARDA IDA - Switching the Device on and off; Switching Stealth Mode on and off

4.2 Switching the device on and off
Narda IDA-3106 45
4.2 Switching the device on and off
Switching on
 Press and hold down the key for a few seconds.
 The device switches on.
You can terminate the switch on process by pressing the Quit softkey.
The device performs a self test during the boot up process. The results are
displayed on the screen.
The screen displayed after switch on depends on the setting of the Power
on function. For more information about this, see Changing the switch on
behavior on page 87.
Switching off
 Press and hold down the key for a few seconds.
 The device switches off.
4.3 Switching stealth mode on and off
Stealth mode allows you to quickly deactivate / reactivate the display and
audio playback. The device will switch off completely after 10 minutes in
stealth mode to conserve battery power.
NOTE: In stealth mode power is not saved significantly, even when the display is
deactivated. Thus, stealth mode will not prevent the batteries from running
empty.
To switch to stealth mode:
 Press the key.
 The screen display and audio playback switch off. The status display
LED flashes briefly every 3 seconds.
To switch off stealth mode and revert to measurement operation:
 Press the key.