Narda IDA-3106 87
5.4.5 Changing the switch on behavior
Main Menu • Setups
You can specify the measurement settings to be used by the device when it
starts up after being switched on:
• Factory Setup: The default factory setup (state as supplied) is used.
• Last Settings: The settings in use at the time the device was last
switched off will be used (default after reset).
• Power On Setup: The setup marked in the Setups menu as the
Power on Setup will be used.
To select the settings:
1. Press the Power on Settings softkey.
The selection window opens.
2. Mark the desired function using the rotary control knob and press OK to
confirm.
To select a setup as the Power on Setup:
Mark the desired setup in the list using the rotary control knob and then
press the Mark Power on Setup softkey.
The selected setup is marked in the list (‹‹...››) and will be loaded the
next time you switch on the instrument.
5.5 The memory menu
Main Menu • Memory
The following functions are contained in the Memory menu:
• Display data sets (Data Viewer)
• Display saved screenshots (Screenshot Viewer)
• Output of recorded demodulated signal content (Demod. Record Viewer)
• Set comment function
• Save data to microSD memory card in csv format
• Configure automatic storage (Time Controlled)
You can find detailed information about all these functions in chapter 13
Measurement Data Memory on page 219.
To Next Page
Loading...
