Chapter 3: Setup 3-11
Disabled
CC00-CDFF
CE00-CFFF
D000-D1FF
Mode
This option is used to set the mode for the parallel port.
1. Move the cursor to the Mode option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Floppy Disk Controller
This option is used to configure the Floppy Disk Controller. Since there
is no floppy disk on the terminal, this option is set to Disable.
Disk-On-Chip Address
This option is used to select the memory address range used by the
Disk-On-Chip.
1. Move the cursor to the Disk-On-Chip option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Output only
Bi-directional
EPP
ECP
To Next Page
Loading...
