NCR RealPOS 70 - Page 134

5-10 Chapter 5: Touch Screen Calibration – Windows (MT 5.64, SR6)
21. Placeyourfingeronthetargetthathasafingericonpointing
towardsitandholdituntilTouchEnableisdisplayedbesidethe
fingericon.
Forbestresults,pressthetargetasaccuratelyaspossible.Hold
yourfingerinplaceuntilnotifiedbythetargetandthenliftyour

fingeroffthetarget.
25408

22. Repeatthisprocedurefortheothertarget.
23. Testthecalibrationbymovingyourfingeraroundonthescreen
andverifyingthatthecursorfollowsyourfinger.Itisalso
suggestedthatyouTouchall4Cornersandverifythatthecursor
movesdeeplyintothecorners.