Item No. Item Input Data Default Note
02 Logical Port Number
The starting port num-
ber of a BRI line is dis-
played. Two logic ports
are automatically as-
signed to a BRI line.
[0:Nosetting]=0
[1:T-Point]=1~126
[2:S-Point]=1~128
[3 ~ 5] = Not Used
[6 : S-Point (Leased Line)]=1~128
0 (V1.5
Changed)
03 Connection Type 0 = Point-to-Multipoint
1 = Point-to-Point
0
04 Layer 3 Timer Type
Each timer value of
Layer 3 is set up for ev-
ery type using Program
81-06 (T-Bus).
1~5 1
05 CLIP Information Announce-
ment
Based on this setting, the system
includes a Presentation Allowed
(1) or Presentation Restricted (0)
in the Setup message to allow or
deny the Calling Party Number.
Program 15-01-04 must also be
set to 1 if this option is enabled.
0=No
1=Yes
1
06 Connection Bus Mode 0 = Extended passive bus
1 = Short passive bus
0
07 S-point DDI digits 0~4 0
08 Dial Sending Mode
ISDN Protocol definition
0 = Enblock Sending
1 = Overlap Sending
1
09 Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending
Mode (10-03-08) is set for 1
(Overlap Sending]
0 = Keypad Facility
1 = Called Party Number
1
10 Master/Slave System
If set to 0, system is synchro-
nized to network clock. If set to 1,
system is not synchronized to the
network clock.
0 = Slave System
1 = Master System
0 (V1.5 Deleted)
11 Networking System No. 0 ~ 50 0 (V1.5 Deleted)
14 Service Protocol for S-point 0 = Keypad facility
1 = Specified Protocol for Aspire system
0
15 Call Busy Mode for S-point 0 = Alerting
1 = Disconnect
0
17 ISDN Line Ringback Tone
System can provide ringback
tone, if set to 1 : Enable.
0=Disable
1=Enable
0
18 Type of Number
ISDN Protocol definition
0 = Unknown
1 = International number
2 = National number
3 = Network specific number
4 = Subscriber number
5 = Abbreviated number
0
19 Numbering Plan Identification
ISDN Protocol definition
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
0
ISSUE 1.1SL1000
Program
10
Program 10 : System Configuration Setup2-6
To Next Page
Loading...
