No
No
Yes
No
Yes
No
Yes
Yes
Stop
Start
In PRG 10-03-01, determine the mode of the
IP4WW-1PRIU-C1 (0=not set, 1=T-Bus)
In PRG 10-03-03,
ebter '0'.
Is the CRC
Multi-Frame
(CRC4)
used?
In PRG 10-03-03,
ebter '1'.
In PRG 10-03-04, select the Layer 3 timer type (1-5). The timer
value is set up in PRG 81-06 (T-Bus)
In PRG 10-03-06, determine the length of cable used to connect from
the CSU to the IP4WW-1PRIU-C1
(0=0-40m, 1=40-81m, 2=81-122m, 3=122-162m, 4=162-200m)
In PRG 10-03-08,
enter '0'.
Is the Dial
Sending Mode
Enblock or
Overlap
Sending?
In PRG 10-03-08,
enter '1'.
Enblock
Overlap
In PRG 10-03-09, select
either Keypad Facility (0) or
Called Party Number (1) for
the dial information element.
PRG 20-08-02,
enter '1' to enable
outgoing calls.
Should system users be able to place
outgoing calls on trunks?
In PRG 20-06-01, assign
Class of Service to extensions.
In PRG 20-08-02,
enter 0 to disable
outgoing calls.
In PRG 20-08-01, ebter
0 to disable calling
number display by Telco.
Should Telco display the
calling number for outgoing
calls?
In PRG 20-08-13, enter
1 to enable calling
number display by Telco.
In PRG 20-13-31,
enter 0 to disable trunk
ID display by Telco.
Should Telco display the
trunk identification for
outgoing calls the extension
places?
In PRG 20-13-31,
enter 1 to enable trunk
ID display by Telco.
Go To
A
To Next Page
Loading...
