NEC SL1000 - Page 692

Program
Number
Program Name Default
20-07-11 Class of Service Options (Administrator Level) - Forced
Trunk Disconnect (analog trunk only)
COS 01~15 = 1
20-11-11 Class of Service Options (Hold/Transfer Service) - Au-
tomatic On-Hook Transfer
COS 01~15 = 1
20-11-14 Class of Service Options (Hold/Transfer Service) -
Trunk-to-Trunk Transfer Restriction
COS 01~15 = 0
20-11-21 Class of Service Options (Hold/Transfer Service) - Re-
striction for Tandem Trunking on Hang Up
COS 01~15 = 0
24-02-07 System Options for Transfer - Trunk-to-Trunk Transfer
Release Warning Tone
1800 (seconds)
24-02-10 System Options for Transfer - Disconnect Trunk-to-
Trunk
0 (seconds)
25-07-07 System Timers for VRS/DISA - Long Conversation
Warning Tone Time
30 (seconds)
25-07-08 System Timers for VRS/DISA - Long Conversation Dis-
connect Time
15 (seconds)
81-01-03 COT Initial Data Setup - Clear Signal (Open Loop) De-
tection Time
59 (295ms)
Method D - Tandem Trunking to Speed Dial Number
Program Num-
ber
Program Name Default
11-10-06 Service Code Setup (for System Administrator)
- Setting the Automatic Transfer for Each Trunk
Line
833
11-10-07 Service Code Setup (for System Administrator)
- Canceling the Automatic Transfer for Each
Trunk Line
834
11-10-08 Service Code Setup (for System Administrator)
- Setting the Destination for Automatic Trunk
Transfer
835
13-04-01 Speed Dialing Number and Name - Speed Dial-
ing Data
not assigned
13-04-02 Speed Dialing Number and Name - Name not assigned
13-04-03 Speed Dialing Number and Name - Transfer
Mode
0
13-04-04 Speed Dialing Number and Name - Transfer
Destination Number
not assigned
13-04-05 Speed Dialing Number and Name - Incoming
Ring Pattern
0
14-01-04 Basic Trunk Data Setup - Transmit Gain Level
for Conference and Transfer Calls
32 (0dB)
14-01-05 Basic Trunk Data Setup - Receive Gain Level for
Conference and Transfer Calls
16 (-8dB)
14-01-13 Basic Trunk Data Setup - Trunk-to-Trunk Trans-
fer
0
20-06-01 Class of Service for Extensions All extension port = Class 1
20-07-05 Class of Service Options (Administrator Level) -
Set/Cancel Automatic Trunk-to-Trunk Transfer
COS 01~15 = 1
20-07-11 Class of Service Options (Administrator Level) -
Forced Trunk Disconnect (analog trunk only)
COS 01~15 = 1
SL1000/SL1100 ISSUE 2.0
1-682
Tandem Trunking (Unsupervised Conference)
T